Then, two PCR products were connected by overlapping PCR with pri

Then, two PCR products were connected by overlapping PCR with primers XbaBTU15FW and BTU13RVXho. The overlapping PCR produced SalI, SmaI and SpeI sites between BTU1_5′ and BTU1_3′. The PCR product was cloned into the XbaI and XhoI sites of pBlueScript SK(+) vector (Stratagene)

to produce pBB. The neo5-MTT1-5′-2 segment was amplified from pMNMM3 by the PrimeStar HS DNA GF120918 ic50 Polymerase with primers neo5_FW_Sal and MTT1_MCS_RV p38 inhibitors clinical trials and cloned into the SalI and SpeI site of pBB. Then, an XhoI site was introduced between XbaI and NotI sites by site-directed mutagenesis with primers pBNMB_addXhoS and pBNMB_addXhoAS to produce pBNMB. neo5-MTT1-5′-2-HA-cre segment of pMNMM3-HA-cre1 was excised out by SalI and MluI and cloned selleck screening library into the SalI and MluI site of pBNMB to produce pBNMB-HA-cre1. The plasmid map and the DNA sequence of pBNMB-HA-cre1 can be found in the Additional file 1. The CU427 wild-type strain was transformed with the BTU1-5′-neo5-MTT1-5′-2-HA-cre1-BTU1-3′ construct which was digested out from pBNMB-HA-cre1 and the transformants were selected using 100 μg/mL paromomycin. The endogenous BTU1 loci were replaced with the construct by phenotypic assortment and selection using increasing concentrations of paromomycin. Six strains were selected for further studies. Induction of Cre-mediated loxP recombination For the experiment shown in Fig. 2A, exponentially growing B2086 or CRE556 cells were cultured

in 1× SPP medium with or without 1 μg/mL CdCl2 for 1.5 hr, or starved B2086 or CRE556 cells were cultured in 10 mM Tris (pH 7.5) with or without 50 ng/mL CdCl2 for 1.5 hr.

For the experiment shown in Fig. 2B, CRE556 and loxP-neo4-loxP-EGFP-TWI1 strains, both pre-starved over night in 10 mM Tris (pH 7.5) were mated and 50 ng/mL CdCl2 was added to the culture at 3.5 hr post-mixing (hpm). At the times indicated, cells were collected for immunofluorescence staining. For the experiment shown in Fig. 3B, starved CRE556 cells were pre-treated with 50 ng/mL CdCl2 for 1.5 hours and then mated with starved these loxP-neo4-loxP-EGFP-TWI1 cells in 10 mM Tris (pH 7.5) in the presence of 25 ng/mL CdCl2. At 2, 4, 6 and 8 hpm, genomic DNA was extracted for loxP excision analysis. For the experiment shown in Fig. 4B, starved CRE556 cells were pre-treated with 50 ng/mL CdCl2 in 10 mM Tris (pH 7.5) for 1.5 hr and then mated with pre-starved loxP-neo4-loxP-EGFP-TWI1 strains in the presence of 25 ng/mL CdCl2. At 2 hpm, single mating pairs were isolated into drops of 1× SPP medium. Cells were observed about every 2 hr until 6 hpm; then, cells were cloned into fresh drops of 1× SPP medium, in cases where pairs had separated. Cells were cultured for 2 days at 30°C and established clones were cultured in 1 mL 1× SPP medium for ~24 hr. The cells were then inoculated into 1× SPP medium containing 1 μg/mL CdCl2. Clones growing at normal speed in this medium were chosen as candidates for loxP-neo4-loxP-EGFP-TWI1 strain derived cells.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>