Since top TCO is considered in this paper to be with 600 nm for electrical consideration unlike what we used in [14], a complete 1D nanopattern design similar to [14] is also performed. Optimized 1D design Selleckchem GSK1838705A yields J tot = 24.49 mA/cm2, which is apparently lower than that under 2D nanophotonic configuration (i.e., J tot approximately 27.72 mA/cm2 with an increment of 3.23 mA/cm2). This arises from the fact that more solar energy is coupled two-dimensionally into the resonant modes in the a-Si:H/μc-Si

active layers under a light-trapping mechanism with 2D photonic crystal [6]. Figure  2e,f is the (overall) absorption spectra (P abs) of the tandem TFSCs under Selleckchem CCI-779 various Λ y . It is obvious that the tandem cell has very good light absorption performance (except that absorbed by top TCO when λ < 400 nm) GNS-1480 nmr in the active band, especially within the band of 400 < λ < 700 nm. For the optimized design (b/Λ = 0.75, Λ x  = 520 nm, and Λ y  = 930 nm) from 2D RCWA, we turn to FEM calculation in order to get the detailed absorption distributions

in the tandem junctions. Absorption spectra for a-Si:H and μc-Si:H layers (i.e., P a-Si:H and P μc-Si:H) are plotted in Figure  3a, where TE, TM, unpolarized, and planar (wo) cases are considered. Compared to the 1D grating design [14], nanopatterning a-Si:H layer into 2D grating further improves the junction capability of harvesting the solar energy. Especially, P μc-Si:H under either TE or TM incidence is dramatically strengthened, e.g., P abs = 71.61% for TE (5.402% for wo) at λ = 886 nm and 79.85% for TM (5.121% for wo) at 902 nm. In addition, there are much more resonant peaks in the spectrum due to the strong cavity effects and the presence of a great deal of diffraction modes excited from the 2D grating. This can be very

beneficial to realize a broadband absorption enhancement. For the top junction, 2D grating also improves the light absorption than 1D case, resulting in a maximized J tot as discussed previously. Figure 3 EQE spectra. P abs and EQE spectra of a-Si:H/μc-Si tandem TFSCs with b/Λ = 0.75, Λ x  = 520 nm, and Λ y  = 930 nm, where a 18-nm ZnO layer is sandwiched by two junctions in (b) (noted: no ZnO layer in (a)). In Figures 3 and 4, ellipses are Farnesyltransferase used to categorize the simulation results. To evaluate the electrical response of each junction, a device simulation which couples both optical absorption and carrier transport are performed [17, 18]. P/i/n setup is assumed for both junctions with p/n doping concentration of 1.3 × 1017/4.3 × 1016 cm−3 and thickness of 10/30 nm (the rest is intrinsic region). Electron (hole) mobility in p/i/n region for top junction is 4.6/4.6/100 (50/0.92/0.92) × 10−6 m2/V/s [17] and carrier mobility 100 times over those in top junction are used for the μc-Si:H junction.