However, due to the scarcity of the element indium on earth and c

However, due to the scarcity of the element indium on earth and consequently the soaring prices, the advantages in nanomaterials were recently investigated for the current-spreading layer, such as graphene, metal nanowires, and carbon nanotubes (CNTs) [6–8]. Graphene has high mobility and high optical transmittance [9]. However, large work function of graphene caused the large turn-on

voltage with inefficient current spreading, which resulted in light emission occurring only near the p-metal regions, especially on p-GaN due to high sheet and contact resistance [10]. Also, the obvious degradation of graphene layer under 20 mW of input power restricted its actual application [11]. Ag nanowire is the strong competitor of graphene due to its intrinsically Selleck Imatinib high conductivity and favorable optical transparency. However, except for the easy oxidation at ambient environment, the electromigration of silver ions under bias could pose a long-term stability issue [12]. Recently, the optical output power of LEDs was first improved by using the combination of graphene film and Ag nanowires Autophagy inhibitor in vivo as current-spreading layer. The sheet resistance decreases from 500 Ω of bare graphene to about 30

Ω because the silver nanowires bridged the grain boundaries of graphene and increased the conduction channels [13]. Among these three Thiamet G nanomaterials, CNTs have the most mature fabrication technology. In this work, AlGaInP LEDs with CNTs only and 2-nm-thick Au-coated CNTs as current-spreading layers were fabricated. The LEDs with Au-coated CNTs showed good current spreading effect. Methods The AlGaInP LEDs

were grown on n-GaAs substrate by metal-organic chemical vapor deposition. Fifteen pairs of Al0.6Ga0.4As/AlAs with distributed Bragg reflectors (DBRs) were grown on 100-nm-thick GaAs buffer layer. The active region was composed of 800-nm-thick 60-period (Al0.5Ga0.5)0.5In0.5P/(Al0.1Ga0.9)0.5In0.5P multiquantum wells, which were sandwiched in p- and n-(Al0.7Ga0.3)0.5In0.5P cladding layer for electron and hole confinement. In order to study the current-spreading effect of CNTs, only 500-nm-thick Mg-doped p-GaP window layer with the doping density of 5 × 1018 cm−3 was grown on top. The 50/150/200-nm-thick Au/BeAu/Au with 100-μm diameter was first deposited and then patterned by wet etching as a p-type electrode. A super-aligned CNT (SACNT) film is drawn continuously from multiwalled CNT arrays [14]. To improve the conductivity of the as-drawn SACNT films, 2-nm-thick Au was further coated on the SACNTs by magnetron sputtering methods [15]. Then the SACNT thin film was put and stuck on the surface of the LED wafer by Van der Waals force. In order to keep the tubes in place, additional 150/300-nm-thick Ti/Au was deposited and patterned on the p-type electrode.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>